Table of Contents
Advertisement
Configuring the Analyzer
This section shows you how to display the setup screens and provides a
few basic procedures to show you how to configure the analyzer
through the remote user interface. The remote user interface software
must be installed on the remote controlling PC. See "Installing the
Remote User Interface" for instructions.
You can also configure the analyzer through the serial
configuration port. See the online Help for details.
To configure the analyzer through the remote user interface, do the
following:
1. Start the remote user interface on the remote controlling PC as
described under "Starting the Remote User Interface".
2. Click
Setup
Note
to display the Setup screens (Figure 14):
Figure 14. Setup Screens
OptiView T1/E1 and DS3/E3 WAN Analyzers
Configuring the Analyzer
awu17s.bmp
43
Advertisement
Table of Contents
