Table of Contents
Advertisement
Minimum moving object size
Set the minimum size of the moving object in pixels that
the panorama camera can detect. Available object sizes
are between 2 and 32.
Move the upper slider to adjust the horizontal (X) size,
and the lower slider to adjust the vertical (Y) size. Direct
input to the text box on the left is also possible.
Maximum moving object size
Set the maximum size of the moving object in pixels that
the panorama camera can detect. Available object sizes
are between 32 and 200.
Move the upper slider to adjust the horizontal (X) size,
and the lower slider to adjust the vertical (Y) size. Direct
input to the text box on the left is also possible.
Test button
Click this button to check the minimum moving object
size and maximum moving object size you have set. The
following window appears under the panorama camera
image.
The minimum moving object size is shown as a blue
square and the maximum moving object size as a green
square.
Minimum moving object size
Maximum moving object size
Number of frames to activate motion detection
If an object moves within the number of frames set here,
it is detected as a moving object. Available number of
frames are between 10 and 40.
Number of frames to activate noise canceller
If noise continues for the period set here, the noise
canceller is activated. Available number of frames are
between 1 and 10.
Luminance for motion detection
Set the luminance for the motion detection. Available
luminance values are between 10 and 60.
Tip
If you point and hold the mouse cursor on the slider or
text box on the Motion detection tab, a recommended
value is displayed as a tool tip.
Setting the Camera
Information (Camera
information Dialog)
The Camera information dialog opens when you select
Camera information from the Tool menu in the main
window.
Using this dialog, you can set information on the
panorama camera, zoom camera and fixed cameras 1
and 2, such as the installation position, IP address and
network properties.
Setting Procedures of Camera
Information
1
Select Camera information under Tool on the
menu bar of the main window.
The Camera information dialog opens.
3
2
4
2
Select the installation position of the panorama
camera from the select box at the top.
3
Select Use panorama camera checkbox.
Also select the checkboxes of other cameras that
you will use.
Clear the checkbox of the camera you do wish to
not use.
4
Enter the IP address and port number of the
cameras you use.
Setting the Camera Information (Camera information Dialog)
5
7
41
Advertisement
Table of Contents
