Master ELIPTICAL E-10 Owner's Manual page 59

EN
4.2 Functions and operations
Auto Scan
After the monitor is power on or press MODE key, the LCD will display all functions values from Time –
Odometer– Calories – Pulse – Speed - Distance.Each value will be held for 6 seconds.
Time
Accumulates total time from 0:00 up to 99:59.The user may preset target time by pressing SET & ENTER
button .Each increment is 1 minute . Automatically count down from targeting value during exercise.
Odometer
Display the total accumulated distance from 0.0 to 9999.User also can press mode key to display the Odometer
value.
Calories
Accumulates calories consumption during training from 0.0 to max.9999 calories.The user may also preset the
target calorie before training by press SET & ENTER button.Automatically count down from targeting value
during exercise. Note: This data is a rough guide which can not be used in medical treatment.
Pulse
Display the user´s heart rate in beats per minute during training.
Speed
Display the current training speed from 0.0 to 99.9 KPH or MPH.
Distance
Accumulates total distance from 0.0 up to 999.9 km or mile.The user may preset target distance by pressing
SET & ENTER button.Automatically count down from targeting value during exercise.
Note:
1) If the computer displays abnormally,please re-install the battery and try again.
2) The batteries must be removed from the appliance before it is scrapped and that they are disposed of safely.
3) While the user starst to do exercise,the Display will show out the workout value automatically.Once stop
exercising over 256 sec,the Display will turn off.But the workout value of odometer will be hold.While user
starts exercise again,workout value of odometer will accumulate continuously.
59