ZyXEL Communications 802.11g HomePlug AV ADSL2+ Gateway P-660HWP-Dx User Manual page 371

Table 168 Firewall Commands (continued)
FUNCTION
Sets
P-660HWP-Dx User's Guide
COMMAND
config edit firewall attack
minute-high <0-255>
config edit firewall attack
minute-low <0-255>
config edit firewall attack
max-incomplete-high <0-255>
config edit firewall attack
max-incomplete-low <0-255>
config edit firewall attack
tcp-max-incomplete <0-255>
config edit firewall set <set
#> name <desired name>
Config edit firewall set <set
#> default-permit <forward |
block>
Config edit firewall set <set
#> icmp-timeout <seconds>
Config edit firewall set <set
#> udp-idle-timeout <seconds>
Config edit firewall set <set
#> connection-timeout
<seconds>
Config edit firewall set <set
#> fin-wait-timeout <seconds>
Appendix G Firewall Commands
DESCRIPTION
This command sets the threshold rate of new
half-open sessions per minute where the P-
660HWP-Dx starts deleting old half-opened
sessions until it gets them down to the
minute-low threshold.
This command sets the threshold of half-open
sessions where the P-660HWP-Dx stops
deleting half-opened sessions.
This command sets the threshold of half-open
sessions where the P-660HWP-Dx starts
deleting old half-opened sessions until it gets
them down to the max incomplete low.
This command sets the threshold where the
P-660HWP-Dx stops deleting half-opened
sessions.
This command sets the threshold of half-open
TCP sessions with the same destination
where the P-660HWP-Dx starts dropping half-
open sessions to that destination.
This command sets a name to identify a
specified set.
This command sets whether a packet is
dropped or allowed through, when it does not
meet a rule within the set.
This command sets the time period to allow
an ICMP session to wait for the ICMP
response.
This command sets how long a UDP
connection is allowed to remain inactive
before the P-660HWP-Dx considers the
connection closed.
This command sets how long P-660HWP-Dx
waits for a TCP session to be established
before dropping the session.
This command sets how long the P-660HWP-
Dx leaves a TCP session open after the
firewall detects a FIN-exchange (indicating
the end of the TCP session).
37