Configuring Device Mode (Bridge); Figure 252 Device Mode (Bridge Mode); Table 178 Device Mode (Bridge Mode) - ZyXEL Communications 35 Series User Manual

ZyWALL 5/35/70 Series User's Guide
Table 177 Device Mode (Router Mode) (continued)
LABEL
Bridge
IP Address
IP Subnet Mask
Gateway IP
Address
Apply
Reset

31.9 Configuring Device Mode (Bridge)

To configure and have your ZyWALL work as a router or a bridge, click MAINTENANCE,
then the Device Mode tab. The following applies when the ZyWALL is in bridge mode.

Figure 252 Device Mode (Bridge Mode)

The following table describes the labels in this screen.

Table 178 Device Mode (Bridge Mode)

LABEL
Current Device
Mode
Device Mode
493
DESCRIPTION
Select this radio button and configure the following fields, then click Apply to set
the ZyWALL to bridge mode.
Enter the IP address of your ZyWALL in dotted decimal notation.
Enter the IP subnet mask of the ZyWALL.
Enter the gateway IP address.
Click Apply to save your changes back to the ZyWALL. After you click Apply,
please wait for one minute and use the IP address you configured in the IP
Address field to access the ZyWALL again.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
This displays whether the ZyWALL is functioning as a router or a bridge.
Chapter 31 Maintenance