IBM High IOPS Adapter Hardware Installation Manual page 16

Plug the other end of the cable (shown below) into an available power source cable.
NOTE
There are two power cables supplied with the IBM High IOPS Duo Adapters, a 2x3 pin supporting one
Duo and a 2x4 pin supporting three Duos. These power cables mate directly to the corresponding aux
power connectors available in most IBM servers.
However some IBM servers utilize a different aux power connector, typically white in color, which is
physically a 2x4 but will not accept the 2x4 cable supplied. For these applications, the 2x3 pin cable is to be
used. Care should be taken to insure that the 2x3 cable mates properly with the 2x4 aux power connector.
Due to the square and "D" shaped housing of the power cable connector and corresponding holes in the
aux power connector, they will only fit together one way.
Return to the installation instructions.
IBM High IOPS Adapter Hardware Installation Guide for ioMemory VSL 3.1.1 ______ _ | _ 16