Using The User Function Switch; To Switch Between Play Mode And Manual Mode With The User Function Switch - Zoom 8080 Operation Manual

Using the USER FUNCTION Switch

The USER FUNCTION switch can be programmed by the user to perform a desired function. The following
four functions are available: switch between Play mode and Manual mode, call up a predefined bank number,
call up a predefined patch number, switch between PRESET groups A/B/C.
In the factory default condition, the switch is set to select PRESET groups.

To switch between Play mode and Manual mode with the USER FUNCTION switch

In Manual mode, the foot switches 1-5 can be used to turn predefined effect modules on and off. To do this, the
following steps are required.
• In Utility mode, set the USER FUNCTION switch parameter to "MANUAL".
• In Utility mode, assign the desired effect modules to foot switches 1-5.
FINE TUNE
COMP EFF1 DIST EQ EFF2
STORE GROUP EDIT UTILITY
(EXECUTE) COMPARE EXIT
ADVANCED GUITAR EFFECTS PROCESSOR
BANK
CONTROL
PEDAL
1 In Play mode, press
UTILITY/PAGE key
the
times to call up the
page shown below.
2 Verify that the "USER
FUNCTION=" item is
set to "MANUAL".
3
Press the
UTILITY/PAGE key
four
times to
call up the page
shown below.
36
Display
CONTROL
SWITCH
INDICATOR
MAX
MIN MAX 1 2 MIN MAX
3 4
1/2 INCREASE
MIN MAX MIN MAX
EFF3 DLY REV TOTAL
CONTROL
MIN
– TYPE + SWITCH
PAGE
BLINK
(DLY:TAP)
PRESENCE OUTPUT
DECREASE
–(TAP/HOLD)
USER
FUNCTION
This is the page for selecting the
function of the USER FUNCTION
three
switch.
If not, use Data entry knob 2 to
select the setting.
This is the page for selecting the
effect modules to be assigned to
foot switches 1-3.
2, 4, 6
1, 3, 5
CONTROL
PEDAL
7
STORE/EXECUTE key
8
USER FUNCTION switch
9
Foot switches 1-5
USER FUNCTION=MANUAL
Fsw ASSIGN:
Data entry knobs 1-4
MIN MAX
UTILITY/PAGE key
UTILITY
PAGE
STORE
(EXECUTE)
USER
FUNCTION
3
SW1=EF1
7 SW2=DST SW3=EF2