Back Up User's Data; Reception Of Flashsys (Rx) Writing Side - Zoom g9.2tt Service Manual

Guitar effects console

Hide thumbs Also See for g9.2tt:

Table of Contents

If necessary, back up the user's effect patch data to avoid an accidental erasing.

* Equipment required

· User's G9.2tt as a transmitter (hereinafter referred to as "the transmitter")

· Another G9.2tt as a receiver (hereinafter referred to as "the receiver")

· Jumper wires

1. Connect [MIDI IN] jack of the master unit to [MIDI OUT] jack of a unit for writing,

and [MIDI OUT] jack of the master unit with [MIDI IN] jack of a unit for writing,

respectively (See below).

2. Turn on the [POWER] SW while holding [AMP SELECT/SYSTEM] key and

[STORE] key, both units are powered on in Flash Sys writing mode for service. In

this mode LCD displays [System Update All: SYS Patch: STO], and rewrite starts

by receiving MIDI data.

LCD displays [System Update All: SYS Patch: STO]. Receiving MIDI data in this

state, LCD displays [System Update Erasing...] and [System Update] in a row.

And writing of FlashSys starts.

LCD display doesn't change after writing completes.

Back Up User's Data

- 24 -

Table of Contents

Show Quick Links

Table of Contents