Sound Adjustments; Adjusting The Sound; Using The Sound Control Memory - JVC KD-S9R Instructions Manual

Adjusting the sound

You can adjust the sound characteristics to your
preference.
1
Select the item you want to adjust.
Each time you press the button, the
adjustable items change as
follows:
BAS
(bass)
VOL
(volume)
Indication To do:
BAS Adjust the bass.
TRE Adjust the treble.
FAD* Adjust the front
and rear speaker
balance.
BAL Adjust the left
and right speaker
balance.
LOUD Boost low and high
frequencies to
produce a well-
balanced sound
at low volume
level.
VOL Adjust the volume.
* If you are using a two-speaker system, set the fader
level to "00."

SOUND ADJUSTMENTS

FAD
TRE
(treble) (fader)
BAL
LOUD
(loudness) (balance)
Range
–06 (min.)
|
+06 (max.)
–06 (min.)
|
+06 (max.)
R06 (Rear only)
|
F06 (Front only)
L06 (Left only)
|
R06 (Right only)
LOUD ON
|
LOUD OFF
00 (min.)
|
50 (max.)
2
Adjust the level.
Equalization pattern changes as you adjust
the bass or treble.
Note:
Normally the control dial works for volume
adjustment. So you do not have to select "VOL" to
adjust the volume level.
Using the sound control
memory
You can select and store a preset sound adjustment
suitable for each playback source.
(Advanced SCM)
Selecting and storing the sound modes
Once you select a sound mode, it is stored in
memory. It will be recalled every time you select
the same source and will be shown on the display.
A sound mode can be stored for each of the
following sources — FM1, FM2, FM3, AM and CD.
• If you do not want to store the sound mode
separately for each playback source, but want to
use the same sound mode for all the sources,
see "To cancel Advanced SCM – SCM LINK" on
page 21.
Select the sound mode you want.
SCM
Each time you press the button, the sound mode
changes as follows:
BEAT SOFT
To increase the level.
To decrease the level.
"Link"
indicator
POP SCM OFF
17