Removal And Reinstallation Of The Cover - Mitsubishi Electric FR-CC2-N Series Instruction Manual

2.2

Removal and reinstallation of the cover

 Removal of the accessory cover and installation of the operation panel
• Loosen the two fixing screws on the accessory cover.
(These screws cannot be removed.)
• To install the inverter operation panel, align its connector on the back with the PU connector of the converter unit, and insert
the operation panel. After confirming that the operation panel is fit securely, tighten the screws. (Tightening torque: 0.40
to 0.45 N·m)
 Removal of the upper main circuit terminal cover
(a) Remove the mounting screws to remove the upper main circuit terminal cover.
(b) With the cover removed, the main circuit terminals can be wired.
• Press the upper edge of the operation panel while pulling
(a)
out the operation panel.
(b)
2. INSTALLATION AND WIRING
2.2 Removal and reinstallation of the cover
1
2
3
4
5
6
7
8
9
10
19