Table of Contents
Advertisement
No.
Appearance
(k)
SET key
(l)
ESC key
(m)
—
4.1.2
Basic operation of the operation panel
Basic operation
Converter output voltage
∗1
monitor (At power-ON)
Parameter setting mode
Parameter clear
Group parameter setting
Hold down
*1
The monitor item can be changed. (Refer to
*2
For the details of fault history, refer to
Parameter setting mode
In the parameter setting mode, converter unit functions (parameters) are set.
Name
Confirms each selection.
When this key is pressed during inverter operation, the monitor item changes.
(The monitor item on each screen can be changed according to the settings of Pr.774
to Pr.776.)
When the initial setting is set
Converter
output voltage
Goes back to the previous display.
Holding this key for a longer time changes the display back to the monitor mode.
Not available for the converter unit.
Input current monitor
Value change
All parameter clear
(Example)
Blinking
∗2
Fault record 1
The last eight fault records can be displayed.
(On the display of the last fault record (fault record 1), a decimal point LED is ON.)
When the fault history is empty,
page
87.)
page
144.
Description
Input
Electric thermal relay
current
function load factor
∗1
The present setting is
displayed.
Parameter write complete!!
Fault history clear
(Example)
Blinking
∗2
Fault record 2
is displayed.
Electronic thermal relay
∗1
function load factor monitor
Alternating
(Example)
Parameter copy
Initial value change list
(Example)
Blinking
∗2
Fault record 8
4. BASIC OPERATION
4.1 Operation panel
1
2
3
4
5
6
7
8
9
10
63
Advertisement
Table of Contents
