Zenoah CHTZ2400 Owner's/Operator's Manual page 15

7. Operation
OP5
OP6
(1)
1. When restarting the engine immediately after
2. Overchoking can make the engine hard to start
■ STOPPING ENGINE (OP3)
1. Release the throttle lever and run the engine for
2. Shift the ignition switch to the "STOP" position.
• Except for an emergency, avoid stopping the
RUNNING IN THE ENGINE
• During the first 20 working hours, do not use the
(1)
■ ADJUSTING IDLING SPEED
• Before adjusting the carburetor, clean the air
(1) air filter
• Idle screw is adjusted in order to ensure a good
(1) Idle screw
With the engine idling (3000 rpm), the blade
should not rotate. We recommend that you
have the dealer or an authorised mechanic
carry out any carburetor adjustments.
NOTE
stopping it, leave the choke open.
due to excess fuel. When the engine failed to
start after several attempts, open the choke and
repeat pulling the rope, or remove the spark plug
and dry it.
a half minute.
IMPORTANT
engine while pulling the throttle lever.
IMPORTANT
hedge-trimmer at maximum power for long
periods.
filter and warm up the engine. (OP5)
safety margin between idle running and clutch
engagement. (OP6)
WARNING
15 