Honeywell Galaxy Manual page 62

Suspended setting denotes a zone that is open during setting of the system that is not a Final, Exit, or
Exit/Entry zone type; this condition is indicated by a blue disk (for open zone) with a horizontal yellow double
headed arrow. Another zone state is Alarm; this is activated by anything that will cause an intruder output to
activate or a tamper condition on the zone; it is indicated by the presence of a red circle around any of the
zone buttons. Also listed are the states of programmed output types. A black circle represents OFF, a green
circle represents ON.
Users can omit zones and test outputs by clicking on the button corresponding to each individual output or
zone. This causes the button to flash: output buttons flash green and grey when they have been provisionally
programmed as active; outputs which are active before being clicked on (i.e. are being provisionally
programmed as inactive) will flash black and grey; to confirm the programming click on the OK button, to
abort the programming click on Cancel. A zone can be omitted by clicking on its button and then pressing
the OK button.
Note: Unlike menu option 32 (OUTPUTS) the outputs are not tested by output type but by output address. If
a zone button is pressed and the zone has not been programmed as omittable then the yellow cross,
which indicates zone omission will flash on the button for approximately 2 minutes and then Galaxy
Gold will abort its attempts at omitting the zone. For more details on testing outputs and omitting
zones see the Galaxy Engineer's manual. Outputs programmed as output type Reset (menu option
51.3.7) cannot be activated from the mimic option.
To return to the Overview card click on the Exit button. This allows you to select another RIO if
desired.
If the RIO being viewed is an RF RIO then the RIO view card indicates the RF specific status of the RIO.
Page 58