Remote Control; Pip (Picture-In-Picture)/Twin Picture; Watching Pip/Twin Picture; Selecting An Input Signal Source For Pip/Twin Picture - Zenith Z44SZ80 Installation And Operating Manual

Operation

Remote Control

Remote Control
PIP (Picture-In-Picture) / Twin Picture
- PIP lets you view 2 different inputs (sources) on your TV screen at the same time. One source will be large, and the other
source will show a smaller inset image.
- Twin Picture mode splits the screen into 2, allowing 2 picture sources to be shown on the TV screen at the same time. Each
source is given half the screen.
- If you set the block/rating for Lock menu options in PIP/Twin Picture mode, "Rating Blocked" doesn't display on screen.
W atching PIP/T win Picture
W atching PIP/T win Picture
Press the PIP button to access the sub picture. Each press of PIP changes the PIP options as shown below.
Selecting an Input Signal Source for PIP/T
Selecting an Input Signal Source for PIP/T
Use the PIP INPUT button to select the input source for the sub picture. Each press of PIP INPUT button changes
the PIP source. You can also select sources for the
Main Picture Source
DTV, Analog
Swapping the PIP
Swapping the PIP
Repeatedly, use the SWAP button to switch the main and sub pictures.
• Component 1, Component 2, RGB-PC (or RGB-DTV), HDMI1/DVI, HDMI2 input sources for the main picture can't
be used to swap the main and sub pictures.
Main Picture
Sub Picture

TV Program selection for PIP

TV Program selection for PIP
1. Press the PIP button.
2. Select the Antenna or Cable option on the Sub input menu or with the PIP INPUT button. Use the PIPCH+
PIPCH- button to select a channel for the sub picture.
(You can't select TV for main and sub picture simultaneously).
34 DLP Projection TV
PIP Mode
PIP Off
Available Sub Picture Sources
Video, and Front Video
/T win Picture
/T win Picture
Twin Picture Mode
win Picture
win Picture
in the menu.
Sub Picture
Main Picture
/