Introduction; Controls - Zenith Z44SZ80 Installation And Operating Manual

Introduction

Introduction
Introduction

Controls

Controls
- This is a simplified representation of a front panel.
- Image shown may be somewhat different from your TV.
POWER
POWER Button
Function Status Indicators
Function Status Indicators
- Lamp indicator, operation indicator, and temperature indicator located below the front panel controls, reveal the
operating status of the DLP projection TV.
Operation Indicator
Lamp Indicator
Temperature Indicator
6 DLP Projection TV
Front Panel Controls
Front Panel Controls
MENU ENTER
MENU Button
VOLUME (
Buttons
ENTER Button
Off
Red
Green
Orange (blinking)
Orange
Red (blinking)
Green (blinking)
Orange
Red
Red (blinking)
VOL CH
F G
, )
E
CHANNEL ( ,
Buttons
Power cord is not connected.
Power Cord is connected, TV is in standby mode.
TV turns on.
Preparing operation in standby mode.
Projection lamp is reaching the end of its life and needs to
be replaced with a new lamp. Contact your service center.
There is a problem with the lamp or around it. Contact an
authorized service center.
The lamp cover is not closed.
The projection TV is overheating. Check for blocked vents on
the projection TV.
The projection TV shut down due to overheating.
The projection TV shut down, check the cooling fan. Contact
your service center.
Operation Indicator/
Lamp Indicator/
D
)
Temperature Indicator