Adjusting The Cutting Height; During Operation; During Operation Safety - Toro TimeMaster 21810 Manual

Adjusting the Cutting Height

DANGER
Adjusting the cutting-height levers could bring your hands into contact with a moving blade
and result in serious injury.
• Shut off the engine, remove the ignition key (if equipped), and wait for all moving parts to
stop before adjusting the cutting height.
• Do not put your fingers under the housing when adjusting the cutting height.
CAUTION
If the engine has been running, the muffler will be hot and can burn you.
Keep away from the hot muffler.
Note:
To raise the machine, move the front and rear cutting-height levers forward; to lower the machine,
move the cutting-height levers rearward. Set all the wheels to the same height unless special circumstances
require otherwise.

During Operation

During Operation Safety

General Safety
•
Wear appropriate clothing, including eye
protection; long pants; substantial, slip-resistant
footwear; and hearing protection. Tie back long
hair and do not wear loose clothing or loose
jewelry.
Figure 13
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
The blade is sharp; contacting the blade can result
in serious personal injury. Shut off the engine,
remove the ignition key (if equipped), and wait
for all moving parts to stop before leaving the
operating position.
13
g224172