Electric Windows; Window Closing; Window Opening; Driver Side Front Door Controls - Jeep Renegade Owner's Handbook Manual

ELECTRIC WINDOWS

ELECTRIC WINDOWS
22)
They operate with the ignition device at
MAR and for nearly 3 minutes after the
ignition device switches to STOP (or
also after the mechanical key has been
extracted, for vehicles equipped with
mechanical key with remote control).
When one of the front doors is opened
this operation is disabled.

Driver side front door controls

The buttons are located on the trims of
the left side door panels (left hand drive
versions) or of the right side door
panels (right hand drive versions). All
windows can be controlled from the
driver side door panel fig 36.
36
A: front left window opening/closing.
32
"Continuous automatic" operation
during window opening/closing stage
and anti-pinch system activated.
B: right front window
opening/closing. "Continuous
automatic" operation during window
opening/closing stage and anti-pinch
system activated.
C: enabling/disabling of rear door
electric window controls;
D: left rear window opening/closing
(if present). "Automatic continuous"
operation during window
opening/closing, manual electric
operation during window closing;
E: right rear window opening/closing
(if present). "Automatic continuous"
operation during window
opening/closing, manual electric
operation during window closing.

Window opening

Push the buttons to open the desired
window.
When any of the opening buttons on
front or rear doors is pressed briefly, the
window moves in stages; if the button
is held down, "continuous automatic"
operation is activated.
If the button is pressed again, the
window will stop in the desired position.
J0A0078C

Window closing

Lift the buttons to close the desired
window.
The window closing stage occurs
following the same logic described for
the opening stage, for the front door
windows only.
The rear door windows can only be
closed "in stages".
Front window anti-pinch safety
device
(where provided)
This safety system can recognise the
presence of any obstacle during the
window closing movement. If this
occurs, the system stops the window's
movement and reverts it by a few
centimetres, depending on its position.
The anti-crush safety function is
activated both during the manual and
the automatic operation of the window.
Electric window system
initialisation
If power supply is interrupted, the
electric window automatic operation
must be reinitialised.
The initialisation procedure described
below must be carried out with the
doors closed and for each door:
fully close the window to be
initialised, with manual operation;
after the window has reached the
upper end of travel, hold the up button
down for at least 3 seconds.