Electric Windows - Jeep COMPASS Owner's Handbook Manual

ELECTRIC WINDOWS

ELECTRIC WINDOWS
56)
The electric window controls on the
driver side door fig. 44 control the
windows of all doors.
44
The electric window controls on each
lining panel of each passenger door
operate solely the corresponding window.
They work with the ignition device in
the ENGINE position and for about 10
minutes after the ignition device has
been turned to the STOP position. When
one of the front doors is opened this
operation is disabled.
57)
"Automatic opening" function
The electric door window lift control on
the driver's side and passenger side are
equipped with an automatic opening
function. Push the window switch down
briefly and release it to open the window
automatically.
For partial window opening, press the
electric window button briefly and
release it when the window is in the
desired position.
To stop the window from going all
the way down during the automatic
operation, pull up on the switch briefly.
Anti-pinch safety device
The car is equipped with an anti-pinch
safety function for the raising of the front
windows.
This safety system can recognise the
presence of any obstacle during the
window closing movement. If this occurs,
the system stops the window's movement
and reverts it, depending on its position.
Remove the obstacle and close the
5520634D
window again using the respective
button.
This device is also useful if the windows
are activated accidentally by children on
board the car.
When the anti-pinch system is activated
the window travel is immediately
interrupted.
Then the window stroke is automatically
inverted.
NOTE Any impact due to rough road
conditions may trigger the auto reverse
function unexpectedly during automatic
closing. If this happens, pull the switch
lightly and hold to close the window
manually.
58)
Resetting the automatic closing
function
If the "Automatic closing" function no
longer works, you may have to perform
a reset cycle. To reset the "Automatic
closing" function:
1. Lift the window lift button to fully
close the window, then hold it in position
for another two seconds after the window
is closed.
2. Press the window lift button firmly
to fully open the window and hold the
button for a further two seconds once the
window is fully open.
Window lockout switch
The window lockout switch on the
driver's door trim panel allows you
to disable the window controls on the
rear passenger doors. To disable the
window controls, push and release the
button indicated in fig. 45, the LED on
the button with turn on. To enable the
window controls, push and release the
button again, the LED on the button goes
off.
51