Tips, Controls And General Information; Road Safety; Reception Conditions; Antitheft Protection - Jeep Renegade Owner's Handbook Manual

TIPS, CONTROLS
AND GENERAL
INFORMATION

ROAD SAFETY

Learn how to use the various system
functions before setting off.
Read the instructions for the system
carefully before setting off.
188) 189)

RECEPTION CONDITIONS

Reception conditions change
constantly while driving. Reception may
be interfered with by the presence of
mountains, buildings or bridges,
especially when you are far away from
the broadcaster.
The volume may be increased when
receiving traffic alerts and news.
CARE AND MAINTENANCE
Observe the following precautions to
ensure the system is fully operational:
the display lens should not come into
contact with pointed or rigid objects
which could damage its surface; use a
soft, dry anti-static cloth to clean and
do not press.
never use alcohol, petrols and
derivatives to clean the display lens.
prevent any liquid from entering the
system: this could damage it beyond
repair.
88) 89)

ANTITHEFT PROTECTION

The system is equipped with an
anti-theft protection system based on
the exchange of information with the
electronic control unit (Body Computer)
on the vehicle.
This guarantees maximum safety and
prevents the secret code from being
entered after the power supply has
been disconnected.
If the check has a positive outcome, the
system will start to operate, whereas if
the comparison codes are not the same
or if the electronic control unit (Body
Computer) is replaced, the system will
ask the user to enter the secret code
according to the procedure described
in the paragraph below.
Entering the secret code
(excluding the versions with a Uconnect
6.5 RadioNav LIVE system)
When the system is switched on, if the
code is requested, the display will show
"Please enter Anti-Theft Code" followed
by the screen showing a keypad to
enter the secret code.
The secret code has four numbers from
0 to 9: to insert the code numbers,
rotate the BROWSE/ENTER dial and
press to confirm.
After entering the fourth number the
system will start functioning.
If an incorrect code is entered, the
system displays "Incorrect Code" to
notify the user of the need to enter the
correct code.
After the 3 available attempts to enter
the code, the system displays
"Incorrect Code. Radio locked. Wait for
30 minutes". After the text has
disappeared it is possible to start the
code entering procedure again.
Vehicle radio passport
(excluding the versions with a Uconnect
6.5 RadioNav LIVE system)
This document certifies ownership of
the system. The vehicle radio passport
shows the system model, serial number
and secret code.
In case you lose the radio passport,
please go to Jeep Assistance Network
with an ID and the car papers.
Keep the vehicle radio passport in a
safe place so that you can give the
information to the relevant authorities if
the system is stolen.
IMPORTANT
In the event of a fault, the system must
only be checked and repaired by a
Jeep Dealership.
If the temperature is particularly low, the
display may take a while to reach
optimum brightness.
213