Table of Contents
Advertisement
HOTKEY – UPLOAD
4.8
When in Programming Menu, it is possible to activate the HotKey Upload Menu function to save the current
device configuration (parameter values) into the external memory. To do this, follow these instructions:
1. H-swipe to go on the UPL screen
2. Insert the HotKey (on the 5-pin ports on the back of the device)
3. Touch the PRG icon for 3 sec
4. The copying procedure will start and the PRG icon will blink during the copy operations
5. At the end of the copying procedure, a message will notify the user that the operation has been
competed successfully:
a. End: all parameters have been copied
b. Err: some error occours during copying operations
HOTKEY – DOWNLOAD
4.9
When in Power-off or in Stand-by mode, it is possible to activate the HotKey Download Menu function to
copy a new configuration (parameter values) into the current device memory. To do this, follow these
instructions:
1. Insert the HotKey (on the 5-pin ports on the back of the device)
2. Touch the OFF icon for 3 sec
3. After power-on, the copying procedure will start automatically and the PRG icon will blink during the
copy operations
4. At the end of the copying procedure, a message will notify the user that the operation has been
competed successfully:
a. End: all parameters have been copied
b. Err: some error occours during copying operations
4.10 X9
Every parameter is normally identified by a unique label that can have two or three alphanumeric characters.
When in "X9" Screen, it is possible to create the parameter label by swiping-up every single part of the label
(first, second and third char). The system is able to drive the user through the symbols, showing only the
available ones to speed up the creation of the label.
For example, if a modification of the "interval between defrosts" parameters is required (label "idF"), these are
the steps to follow:
-
Enter the X9 Screen
Swipe-up or down the first char position (lower segment on the left) until char "i" (lower case) appears
-
Move to the second char position (segment in the middle) and swipe-up or down until char "d" appears
-
Move to the third char position (segment on the right) and swipe-up or down until char "F" appears
-
-
Enter the par. value by touching the PRG icon for 3 sec.
1592040010 XRi30-31T EN v1.2 2020.08.26
XRi30T-XRi31T
11/42
Advertisement
Table of Contents
