Draytek Vigor 2862 Series Quick Start Manual page 7

V i g o r 2 8 6 2 a c
V i g o r 2 8 6 2 a c
LED
ACT (Activity)
WAN2
QoS
DSL
WCF
USB
2.4G
5G
DMZ
LED on Connector
Left
LAN P1~P4
LED
P5/WAN2
Right
LED
The port "P5/WAN2" is switchable. It can be used for LAN connection or WAN connection
according to the settings configured in WUI.
Status Explanation
Off The router is powered off.
Blinking The router is powered on and running normally.
On Internet connection is ready.
Off Internet connection is not ready.
Blinking The data is transmitting.
On The QoS function is active.
Off The QoS function is inactive.
On The router is ready to access Internet through DSL
link.
Blinking Slowly: The DSL connection is ready.
Quickly: The connection is training.
On The Web Content Filter is active. (It is enabled
from Firewall >> General Setup).
Off WCF is disabled.
On USB device is connected and ready for use.
Off No USB device is connected.
Blinking The data is transmitting.
Wireless access point is ready.
On
Off Wireless function is disabled.
It will blink slowly while wireless traffic goes
Blinking
through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will
return to normal condition after two minutes.
(You need to setup WPS within 2 minutes.)
On The DMZ function is enabled.
Off The DMZ function is disabled.
Blinking The data is transmitting.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Off The port is connected with 10/100Mbps
4