Table of Contents
Advertisement
4.8 Setting the saw blade speed
WARNING!
Pull out the mains plug before you open the protective cover. Close and screw down the
protective cover after each change of speed.
▲ Disconnect the metal bandsaw from the power supply.
▲ Slacken the V-belt with the tensioning screw and Allen screw on the motor.
▲ Place the V-belt in the required position on the pulleys.
▲ Tighten the V-belt with the tensioning screw and Allen screw on the motor.
▲ Check the V-belt tension.
▲ Close and bolt down the protective cover.
INFORMATION
It is impossible to start the machine when the protective cover is not closed.
ATTENTION!
Ensure that the V-belt is tensioned correctly. Too high or too low tension of the V-belt can
cause damage.
23
Advertisement
Table of Contents
