Kenwood KWL90 Instructions Manual page 9

Note: Spanner shown is for illustration
purposes only and is not supplied in
pack.
Optional Attachments
There are a range of optional
attachments available to use with
your Stand Mixer. See the attachment
leaflet included in your pack or visit
www.kenwoodworld.com to see the full
range and how to buy an attachment
not included in your pack.
Note: Slow Speed Outlet Attachments
The slow speed outlet on your Stand
Mixer model features the Twist
Connection System. It is designed
to accept Twist Connection System
attachments.
When purchasing new attachments for
the slow speed outlet you should check
compatibility with your Stand Mixer. All
Twist Connection System attachments
can be identified by the product code
which starts with KAX and also by
the Twist logo which is visible on
packaging. For more information visit
www.kenwoodworld.com/twist.
If you own attachments featuring the
Bar Connection System
need to use the KAT002ME adaptor to
connect these to the Twist Connection
System on your Stand Mixer.
For more information visit
www.kenwoodworld.com/twist.
To Use Your Stand Mixer -
Manual Mode
Refer to Illustrations
Make sure the warming plate area,
temperature sensor and external
surface of the bowl base are clean.
Failure to do this will affect the
temperature sensor, resulting in poor
warming performance.
1 Plug in and press the On/Off switch.
2 Push the head-lift lever down and
raise the mixer head until it locks.
3 Fit the bowl, turn clockwise to lock.
you will
A I
–
4 Place the required tool into the
socket. Then push up and turn the
tool to lock into position.
5 Lower the mixer head by pushing the
head release lever down and lower
the mixer head until it locks.
6 Set the required time, speed and
warming level.
Turn the control dial clockwise to
use continuous speeds, turn anti-
clockwise to use stir intervals and
pulse (P).
Press and hold the control dial to
activate the pulse.
7 Press the control dial to start.
8 To stop/pause the unit at any time
press the control dial.
9 Release the tool by turning clockwise
to unlock from the tool socket and
then remove.
Important
Ensure that no bowl tools are fitted or
stored in the bowl when using other
outlets.
Using Preset Programmes
Refer to Illustrations
1 Swipe right to access the preset
menu.
2 Choose the preset you wish to use.
3 Follow the instructions on the
display screen.
4 Press the control dial to start.
5 To stop the unit at any time, press
the control dial. Take care as the
bowl may be hot.
After Warming
Be careful when handling or
touching any part of the appliance
when being used in warming mode
or after warming, IN PARTICULAR
THE BOWL, WARMING PLATE AND
TOOLS as they will remain HOT
long after the appliance has been
switched off.
5
J L
–