Remote Control Operation; General Transmitter Layout; Initializing The Transmitter For The First Time - Napoleon High Definition Series Installation And Operation Manual

11.1 general transmitter layout

Transmission
Flame ON
Blower

11.2 initializing the transmitter for the first time

Power the receiver.
A.
Press the reset button to begin the programming process.
B.
The receiver will BEEP 3 times to indicate that it is ready to synchronize with a
C.
transmitter.
Install the 3 AAA batteries into the transmitter battery bay, located on the base of the
D.
transmitter, then press the "ON" button. The receiver will BEEP 4 times to indicate the
transmitter's command is accepted and sets to the particular code of that transmitter.
The system is now initialized.
NOTE: THE INITIALIZING PROCESS MUST BE COMPLETED WITHIN 10 SECONDS
OF PRESSING THE RESET/PROGRAMMING BUTTON.
RESET
BUTTON
RECEIVER

11.0 remote control operation

remote control operation
Key Lock
Low battery alarm
Light
Room
Temperature
CPI mode
TRANSMITTER
W415-1596 / B / 10.12.18
EN
37