Figure 25: Pnpll With 3 Application Time Blocks (Application Connection) - Siemens ERTEC 200P-2 Manual

The PN-PLL contains a clock instance (Clock_A), a time instance and 3 application timer
blocks. Each application timer block controls its own application cycle and is connected to
the Clock_A instance. The application clock (APPL1/2/3_CLK_INT) and 6 programmable
phase signals (APPL1/2/3_ CMP_INT5...0) are available as outputs for each application
timer block. These
(PNPLL_OUT20...0). Any output of the 3 application timer blocks can be selected at each
MUX output. The controlled clock of the clock instance (PNCLKA_OUT) can also be
connected to the MUX outputs.
Figure 24 shows how these outputs (PNPLL_OUT20...0) are connected to the application
instances at the ERTEC 200P top level.

Figure 25: PNPLL with 3 application time blocks (application connection)

The connection matrix is as follows:
GPIO
PNPLL0 GPIO0_INT
PNPLL1 GPIO1_INT
PNPLL2 GPIO2_INT
PNPLL3 GPIO3_INT
PNPLL4 GPIO4_INT
PNPLL5 GPIO5_INT
PNPLL6 GPIO6_INT
PNPLL7 GPIO7_INT
PNPLL8 GPIO8_INT
PNPLL9
PNPLL10
PNPLL11
PNPLL12
PNPLL13
PNPLL14
PNPLL15
PNPLL16
PNPLL17
PNPLL18
PNPLL19
PNPLL20
Copyright © Siemens AG 2016. All rights reserved
Technical data subject to change
21 outputs are
ARM- GDMA
ICU
IRQ72
IRQ73
IRQ74 HWJob(0)
IRQ75 HWJob(1)
IRQ76 HWJob(2)
IRQ77 HWJob(3)
HWJob(4)
HWJob(5)
HWJob(6)
HWJob(7)
HWJob(8)
HWJob(9)
233
connected to a 21-input multiplexer
ERTEC 200P-2 Manual
Version 1.0