Table of Contents
Advertisement
User manual
4.6
Editing IP/Service combinations
1 Press the Setup button associated with the IP/Service combination to be edited.
2. Make the required changes.
3. Press OK
4. Press Submit in the Configuration window.
5. Press the Apply button when all configuration actions are completed..
4.7
Specifying Service ID's
Each service listed in the Select services window has by default an automatically assigned Service ID (SID), which is displayed in the Output SID
column. The Service ID can, however, be manually specified.
1 Press the Setup button associated with the IP/Service combination to be edited.
2. Change the SID to an unallocated number within the number range '1 to 65535'.
3 Press the Submit button.
An error message is displayed if the manually specified Service ID is incompatible.
1 Press OK on the error message.
2. Change the Service ID for the IP address/Service specified in the error message.
3. Press OK.
4. Press Submit in the Configuration window.
5. Press the Apply button if all configuration actions are completed.
4.8
Licence restrictions
This warning is displayed if more services have been selected than the number of valid licenses. It is not possible to add additional configuration
lines if the number of valid licenses have been exceeded.
19
,
EN
Advertisement
Table of Contents
