Table of Contents
Advertisement
Radio
The radio is programmed to automatically search the entire band at three
sensitivity levels. During its first sweep, only the most powerful stations
received will be selected and locked in. During the next sweep, the less power
ful and during the third sweep, the weak stations will also be locked in.
>
F IR S T SW EEP
SE C O N D SW EEP
T H IR D SW EEP
If the station seeker bar is activated within 8 seconds after the radio is tuned to
a station, then the search operation will be continued at the same sensitivity
level. If 8 seconds are exceeded, the radio will revert to searching only the most
powerful stations.
Direct frequency dialing
In order to select a station with a known frequency, select the wave band, press
the function control button □
corresponding push buttons.
Example:
Press any button marked
Press the function button
Enter frequency by pressing
When dialing a frequency directly, the number of the push buttons is not
displayed on the panel. The wave band is indicated by showing " MHz" for FM
or " KHz" for AM.
40
— riii if f iiiiii ii'iim iniiFii iiiiiiiii ii m i
and then enter the frequency by pressing the
FM 98.5 MHz
EE
through
□
ED, EH S3
m a a m w m m m
h H H H i
i ss i
AM 1050 KHz
QQ
HiJ
ED
through
□
EE. ED. EE ED
Note:
All AM stations have allocated fre
quencies ending with a " 0" .
All FM stations have allocated fre
quencies ending with an odd
(uneven) digit after the decimal point.
Broadcasters sometimes may not
give their exact frequency but the
next closest even number.
US radio frequency ranges:
AM 540 -1 60 0 KHz
FM 88.1-107.9 MHz
Manual tuning (used to fine tune a
station or for manual scanning)
After selecting the desired AM or FM
wave band, press the function control
button □
Press automatic station seeker
bar
(up or down) and hold.
The frequency will increase or
decrease respectively in increments
of 0.1 MHz for FM or 1.0 KHz for AM.
Release the button when the desired
station is tuned in.
Unless the automatic station seeker
bar H S X B B is activated within
8 seconds after pressing the function
control button □
the manual tuning
will automatically be deactivated.
Advertisement
Table of Contents
