Recommended Materials And Equipment; Operating Guidelines - HP ProDesk 400 G7 SFF Maintenance And Service Manual

Keep work area free of nonconductive materials such as ordinary plastic assembly aids and polystyrene
●
foam.
Use field service tools, such as cutters, screwdrivers, and vacuums, that are conductive.
●

Recommended materials and equipment

HP recommends the these materials and equipment to prevent static electricity.
● Antistatic tape
Antistatic smocks, aprons, or sleeve protectors
●
Conductive bins and other assembly or soldering aids
●
Conductive foam
●
● Conductive tabletop workstations with ground cord of 1 MΩ ±10% resistance
Static-dissipative table or floor mats with hard tie to ground
●
Field service kits
●
● Static awareness labels
Wrist straps and footwear straps providing 1 MΩ ±10% resistance
●
Material handling packages
●
Conductive plastic bags
●
● Conductive plastic tubes
Conductive tote boxes
●
Opaque shielding bags
●
● Transparent metallized shielding bags
Transparent shielding tubes
●

Operating guidelines

This information details how to prevent overheating and to help prolong the life of the computer.
Keep the computer away from excessive moisture, direct sunlight, and extremes of heat and cold.
●
Operate the computer on a sturdy, level surface. Leave a 10.2 cm (4 inch) clearance on all vented sides of
●
the computer and above the monitor to permit the required airflow.
● Never restrict the airflow into the computer by blocking any vents or air intakes. Do not place the keyboard,
with the keyboard feet down, directly against the front of the desktop unit as this also restricts airflow.
Occasionally clean the air vents on all vented sides of the computer. Lint, dust, and other foreign matter can
●
block the vents and limit the airflow. Be sure to unplug the computer before cleaning the air vents.
● Never operate the computer with the cover or side panel removed.
14 Chapter 3 Routine care, SATA drive guidelines, and disassembly preparation ENWW