Computer Setup-Main - HP ProDesk 400 G7 SFF Maintenance And Service Manual

1. Turn on or restart the computer.
2. Repeatedly press
You can also press
including the Computer Setup utility.
A choice of four headings appears in the Computer Setup Utilities menu: Main, Security, Advanced, and UEFI
Drivers.
NOTE:
repeatedly press
NOTE:
application. You can access this application directly by pressing
3. Use the arrow (left and right) keys to select the appropriate heading. Use the arrow (up and down) keys to
select the option you want, and then press enter. To return to the Computer Setup Utilities menu, press
esc.
4. To apply and save changes, select Main > Save Changes and Exit.
● If you have made changes that you do not want applied, select Ignore Changes and Exit.
To restore settings from the Advanced and Main menus to original values, select Apply Factory
●
Defaults and Exit.
● To restore settings from the Advanced and Main menus to those previously saved by Save Custom
Defaults, select Apply Custom Defaults and Exit. If no custom defaults have been saved, then factory
defaults are used.
NOTE:
values by selecting Restore Security Settings to Factory Defaults at the bottom of the Security menu.
NOTE:
IMPORTANT:
because the settings could become corrupted. It is safe to turn off the computer only after exiting the F10 Setup
screen.
Computer Setup—Main
This table provides information about the Computer Setup Main menu.
NOTE: Support for specific Computer Setup options can vary, depending on the hardware configuration.
76 Chapter 6 Computer Setup (F10) Utility
f10 when the power button light turns white to access the utility.
esc to see a menu that allows you to access different options available at startup,
If you do not press f10 at the appropriate time, you must restart the computer and again
f10 when the power button light turns white to access the utility.
Selecting UEFI Drivers restarts the computer into the third-party option ROM management
You cannot modify settings in the Security menu by selecting Apply Defaults. You reset those
Not all settings shown in the following sections are available for all models.
Do not turn computer power off while the BIOS is saving the Computer Setup (F10) changes
f3 during startup.
ENWW