Consumption Values - Zanussi ZDT 420 User Manual

of the dishwasher door.. So that you always
have these numbers at hand, we recommend
you to make a note of them here:
Mod. :. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The dishes are not clean
The dishes are wet and dull
There are streaks, milky spots or a bluish coating on
glasses and dishes
Water drops have dries onto glasses and dishes
If after all these checks, the problem persists,
contact your local Service Force Centre.

Consumption values

The consumption values are intended as a
guide and depends on the pressure and the
temperature of the water and also by the var-
22
The wash results are not satisfactory
• The wrong washing programme has been selected.
• The dishes are arranged in such a way as to stop
• The spray arms do not rotate freely due to incorrect
• The filters in the base of the washing compartment
• Too little or no detergent has been used.
• Where there are limescales deposits on the dishes;
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
• Rinse aid was not used.
• The rinse aid dispenser is empty.
• Decrease rinse aid dosing.
• Increase rinse aid dosing.
• The detergent may be the cause. Contact the de-
water reaching all parts of the surface. The baskets
must not be overloaded.
arrangement of the load.
are dirty or incorrectly positioned.
the salt container is empty or the incorrect level of
the water softener has been set.
tergent manufacturer's consumer care line.
iations of the power supply and the amount of
dishes.