Tripp Lite OMNIVSX850 Owner's Manual page 7

Basic Operation
Battery Power Mode LCD Data
The LCD touchscreen offers five screens of UPS and site power information when the UPS is
operating in line-power mode. Screens 1-4 (Output Voltage, Input Voltage, Load %, Battery Charge
Level) are available for viewing in line-power mode. Press the front panel LCD to advance to the next
screen. Screen 5 (Overload) is displayed automatically only when the UPS is loaded to levels greater
than 110%.
1
Output Voltage
4
Battery Charge Level
Note: The touchscreen LCD will remain ON continuously during battery mode operation.
Critical Fault Screens
Error Code Critical Fault
F01 OUTPUT SHORT
F02 OVER LOAD
F03 OVER CHARGE
F04 BATTERY LOW
VOLTAGE
F05 BATTERY MODE
HIGH OUTPUT
18-07-252-93388F.indb 7
2
Input Voltage
5
Overload
Solution
Disconnect load(s) from UPS outlets. Power off UPS and
contact Tripp Lite Technical Support for assistance.
Remove excess load, check load meter on LCD for load status.
Turn unit off, unplug UPS and contact Tripp Lite Technical
Support for assistance.
Charge UPS for 24 hours. If problem persists, replace battery
and contact Tripp Lite Technical Support if problem persists.
Turn off power to the UPS and contact Tripp Lite Technical
Support for assistance.
7
3
Load %
10/3/2018 10:10:25 AM