Toshiba TDP590 Manual page 35

Rear Projection
When you turn on, the projector reverses the image so
Rear Projection
you can project from behind a translucent screen. Highlight Rear Pro-
jection, then click either mouse button to turn this feature on and off.
Default Source
Default Source toggles between Computer and Video. This determines
which source the projector checks first for active video during power-
up. Highlight Default Source and click either mouse button to toggle
between the options.
Auto Source Select
This setting toggles between On and Off. When this feature is Off, the
projector defaults to the source selected in Default Source. To display
another source, you must manually select one by pressing the
source
button on the keypad. When this feature is On, the projector automati-
cally finds the active source, checking the default source first. Highlight
Auto Source Select and click either mouse button to turn this feature on
and off.
Plug and Play
This setting toggles between On and Off. When it is On, most new com-
puters will automatically recognize the projector, then set the monitor
resolution and refresh rate accordingly. You need to set the Plug and
Play setting to Off for the projector to display properly on some older
computers. The Plug and Play setting does not affect video images.
If the projector's display constantly changes between the computer
image and the message, "Perfecting the image", you may need to set
Plug and Play to Off.
Display Messages
This setting toggles between On and Off. When this feature is On, status
messages such as "No signal detected" or "Standby Active" appear in
the lower-right corner of the screen. Click either mouse button to turn
this feature off and not see status messages.
29