Toshiba TDP590 Manual page 20

A/V cable
Connecting the projector to a video player using an S-video cable and the audio
4 Plug the A/V cable's white connector into the left "audio out" port
on your video player. Plug the cable's red connector into the right
"audio out" port on the video player (Figure 11 and Figure 12).
If you're using an S-video cable, the yellow connectors on the
•
A/V cable remain unused (Figure 12).
5 Plug the A/V cable's other white and red connectors to the left and
right "audio in" ports on the projector.
The projector is compatible with these major broadcast video standards:
NTSC, NTSC 4.43, PAL, PAL-M, PAL-N, and SECAM. It automati-
cally adjusts to optimize its performance for the incoming video. The
input signals for SECAM, PAL-M, and PAL-N video are similar to other
video signals and cannot be automatically detected, therefore they must
be chosen manually. See "Video Standard" on page 28 for details.
S-video cable
connectors on the standard A/V cable
F 12
IGURE
CAUTION: Your video player
may also have a "Video Out"
port for a coaxial cable connec-
tion.
DO NOT use this to connect to
the projector.
13