Advertisement
No Parts needed for this step.
Removing the Existing Mower
Pulley
Note: Clean the area around pulley before removing
pulley assembly. Hold spindle up from underneath the
deck. It can fall when nut and washer are removed.
1. Turn the mower over.
2. Remove the right belt cover from the mower and
discard.
3. Remove the nut and washer on top of the spindle
(Fig. 17). Save the nut and washer.
4. Remove the existing pulley assembly.
No Parts needed for this step.
Modifying a 44 inch Mower for
Belt Clearance
Note: This section is only for 44 inch mowers.
1. Remove the right rear corner of the pulley cover plate
(Fig. 16). This will give clearance for the blower belt.
2. Refer to Figure 16 for the correct dimensions of the
cutout.
Note: Do not cut out the stud in the back of the pulley
cover plate. The stud is needed for the pulley cover.
2
3
5
1
Figure 16
1. 44 inch mower
2. Remove this corner
3. 3–1/4 inches
9
4
4
m–6227
4. 1 inch
5. Pulley cover stud
Advertisement
