Advertisement
Parts needed for this step:
1 Tunnel baffle—rear
3 Carriage bolt, 5/16 x 5/8 inch
3 Flange nut, 5/16 inch
Installing the Rear Tunnel
Baffle
1. Place the rear tunnel baffle against the rear wall of the
discharge tunnel (Fig. 7).
Note: The rear tunnel baffle must not extend past the
outside of the mounting bracket.
2. Align the rear tunnel baffle, flush with the outside of
the mounting bracket (Fig. 7).
2
1
3
4
m–6224
Figure 7
1. Rear tunnel baffle
2. Mounting bracket
3. Flush edge with outside of
mounting bracket
3. Clamp the baffle in place.
4. Outside of mounting
bracket
4. Using the baffle as a template, center punch and drill
3 holes (11/32 inch dia.) into the top of the mower
(Fig. 6).
5. Remove the clamp.
6. Install the rear tunnel baffle with 3 carriage bolts
(5/16 x 5/8 inch) and 3 flange nuts (5/16 inch) (Fig. 8).
Important
Make sure the bolt heads are installed on
the inside of the cutting chamber.
2
4
4
Figure 8
1. Rear tunnel baffle
2. Carriage Bolt, 5/16 x
5/8 inch
3. Flange nut, 5/16 inch
5
1
6
5
4
3
m–6173
4. Hole to drill
5. Tunnel rear wall
6. Mounting bracket
Advertisement
