Troubleshoot Ing Guide - Kenwood KDC-4060RG Instruction Manual

Troubleshoot ing Guide

What might appear to be a malfunction in your unit may just be the result of slight misoperation or misw iring. Before
calling service, first check the follow ing table for possible problems.
PROBLEM
The pow er does not turn on.
No sound can be heard, or the
volume is low .
Nothing happens w hen the
buttons are pressed.
The sound quality is poor or
distorted.
Radio reception is poor.
The memory is erased w hen
the ignition is turned off.
A CD ejects as soon as it is
loaded.
The sound skips on a CD.
The specified track does not
play.
POSSIBLE CAUSE
The fuse has blow n.
No ACC position on vehicle ignition.
The Attenuator function is turned on.
The fader and/or balance settings are set all the w ay to
one side.
The input/output cables or w iring harness are connected
incorrectly.
The computer chip in the unit is not functioning normally.
A speaker cable may be pinched by a screw in the car.
The speakers are not w ired correctly.
The car antenna is not extended.
The antenna control cable is not connected.
The battery cable has not been connected to the proper
terminal.
The ignition and battery cable are incorrectly connected.
The CD is upside-dow n.
The CD is quite dirty.
The CD is scratched or dirty.
Random play has been selected.
After checking for short circuits in the cables, replace the
fuse w ith one having the same rating.
Connect the same cable to the ignition as the battery cable.
Turn off the Attenuator function.
Reset the fader and/or balance settings.
Reconnect the input/output cables and/or the w iring harness
correctly. See the section on "Connecting Cables to
Terminals".
Press the reset button on the unit (see page 4).
Check the speaker w iring.
Reconnect the speaker cables so that each output terminal
is connected to a different speaker.
Pull out the antenna all the w ay.
Connect the cable correctly, referring to the section on
"Connecting Cables to Terminals".
Connect the cable correctly, referring to the section on
"Connecting Cables to Terminals".
Connect the cable correctly, referring to the section on
"Connecting Cables to Terminals".
Load the CD w ith the labelled side up.
Clean the CD, referring to the section on "Cleaning CDs" (see
page 5).
Clean the CD, referring to the section on "Cleaning CDs" (see
page 5).
Turn off the random play function.
— 26 —
SOLUTION