Table of Contents
Advertisement
This chapter will show you how to configure the basic functions of your CPE within minutes.
A computer with wired Ethernet connection to the Wireless CPE is required for the first-time
configuration.
4.1
Manual Network Setup -- TCP/IP Configuration
The default IP address of the WBS-202N/WBS-502N is 192.168.1.253. And the default Subnet Mask is
255.255.255.0. These values can be changed as you want. In this guide, we use all the default values for
description.
Connect the WBS-202N/WBS-502N with your PC by an Ethernet cable plugging in LAN port on one side and in
LAN port of PC on the other side. Please power on the WBS-202N/WBS-502N by PoE switch through the PoE
port.
In the following sections, we'll introduce how to install and configure the TCP/IP correctly in Windows 10. And
the procedures in other operating systems are similar. First, make sure your Ethernet Adapter is working, and
refer to the Ethernet adapter manual if needed.
Configuring the IP Address Manually
Summary:
Set up the TCP/IP Protocol for your PC.
Configure the network parameters. The IP address is 192.168.1.xxx (If the default IP address of the
WBS-202N/WBS-502N is 192.168.1.253, and the DSL router is 192.168.1.254, the "xxx" can be
configured to any number from 1 to 252.) and subnet mask is 255.255.255.0.
1
Select Use the following IP address, and then configure the IP address of the PC.
2
For example, as the default IP address of the WBS-202N/WBS-502N is 192.168.1.253 and the DSL router
is 192.168.1.254, you may choose from 192.168.1.1 to 192.168.1.252.
Chapter 4. Quick Installation Guide
-14-
User Manual of WBS-202N/WBS-502N
Advertisement
Table of Contents
