Yamaha YP250A 1999 Supplementary Service Manual page 32

H Fasten the sidestand switch lead
and battery positive lead with a
steel clamp on the frame.
I Fasten the sidestand switch lead
with a plastic clamp.
J Route the battery negative lead
through the front and lower side of
the flasher relay.
K Fasten the wireharness, AC mag-
neto lead, starter motor lead and
engine ground lead with a steel
clamp on inside of the frame.
CABLE ROUTING
L Fasten the AC magneto lead,
starter motor lead and engine
ground lead with a steel clamp on
the engine bracket.
M Route the crankcase breather
hose into the hole of air filter case.
N Route the fuel hose over the vacu-
um hose.
O Position the end of the clip to out-
side.
P Fasten the front wheel sensor and
electronic control unit lead to the
frame with a plastic band.
24
SPEC
Q Install the fuse box to the stay on
the frame.
R Fasten the front wheel sensor,
fuse lead and electronic control
unit lead to the frame with a plastic
band.
S Do not fasten the fuel tank over
flow hose with a plastic band.