Yamaha YP250A 1999 Supplementary Service Manual page 30

M Fasten the wireharness, seat lock
cable and pipe with a steel clamp
on the frame.
N Fasten the front wheel sensor lead
and front brake hose with a plastic
clamp. Position the clamp (loca-
tion of the front wheel sensor) to
front of the upper clamp and
another clamps to outside.
O Route the front wheel sensor lead
between the caliper and caliper
bolt. Do not route as dotted line.
CABLE ROUTING
P Route the front wheel sensor lead
through the guide.
Q Fasten the pipe with a steel clamp
on the frame.
R Fasten the fan motor lead, side-
stand switch lead and starter
switch lead to the frame with a
plastic band.
S Route the wireharness over the
rear brake hose.
T Route the coolant reservoir tank
over flow hose through the guide
on the inside of the frame.
22
SPEC
U Fasten the wireharness to the
frame with a plastic band.
V Route the brake hose, wirehar-
ness and battery leads through the
guide.
W Fasten the battery leads and wire-
harness with a steel clamp on the
frame.
X Fasten the wireharness with a
steel clamp on the frame.
Y Position the connector of plastic
band as illustration.
Z Clearance: 1 mm or more