Yamaha YP250A 1999 Supplementary Service Manual page 29

A Route the box light lead through
from the outside of the frame to the
inside of the pipe.
B Connect the taillight lead and wire-
harness on the mudguard.
C Fasten the fuel sender lead to the
pipe with a plastic clamp.
D Fasten the fuel sender lead and
auto choke lead with a steel clamp
on inside of the frame.
CABLE ROUTING
E Fasten the seat box light switch
lead to the hinge with a plastic
locking tie. Route the plastic lock-
ing tie into the hole and under the
projection of hinge.
F Route the box switch lead under
the projection of fuel tank hinge.
G Route the box switch lead from
outside of the fuel tank over flow
hose to inside of the pipe.
H Fasten the electronic control unit
leads (3 lines) with a plastic band.
21
SPEC
I Route the seat lock cable through
the pipe, and align the mark of seat
lock cable with the pipe end.
J Fasten the wireharness and seat
lock cable with a steel band on the
frame.
K Position the junction of the thermo
switch lead inside of the scooter.
L Align the location tape with the
steel clamp on the frame, and fas-
ten them.