Table of Contents
Advertisement
11. Empty the container used to collect the rinsing water. Re-
move the water tank, replace the water softener filter (if
removed previously), fill the tank up to the MAX level with
cold water and insert in the appliance. The
light flashes.
12. Place the container used to collect the rinsing water empty
under the cappuccino maker;
13. Turn the steam/hot water dial to the I position. Rinsing
continues from the cappuccino maker only.
14. When it finishes, the
trol panel. Turn the steam/hot water dial to the 0 position.
15. Top up the water tank with fresh water to the MAX level
and put back in the machine.
The descaling cycle is now complete.
Please note!
•
If the descaling cycle is not completed correctly (e.g. no
electricity) we recommend repeating the cycle;
•
After descaling, it is normal for the grounds container
(A13) to contain water;
•
If the water tank has not been filled to the MAX level, at
the end of descaling, the appliance requests a third rinse to
guarantee that the descaler solution has been completely
eliminated from the machine's internal circuits.
18. SETTING WATER HARDNESS
Descaling is necessary after a period of operation established
according to the water hardness set.
The machine is set by default for a hardness level of 4. The ma-
chine can also be programmed according to the hardness of the
mains water in the various regions so that the machine needs to
be descaled less often.
18.1 Measuring water hardness
1. Remove the "TOTAL HARDNESS TEST" indicator paper (C1)
from its pack (attached to the English instructions);
2. Immerse the paper completely in a glass of water for one
second;
3. Remove the paper from the water and shake lightly. After
about a minute, 1, 2, 3, or 4 red squares form, depending
on the hardness of the water. Each square corresponds to
one level;
Indicator paper
steam light flashes on the con-
Water
Corresponding
hard-
setting
ness
low
medium
steam
18.2 Setting water hardness
1. Make sure the appliance is off (but connected to the mains
electricity supply and with the main switch (A6) in the I
position);
2. Press and hold the
The ,
3. Press the
(as measured by the indicator paper - see table in previous
section).
4. Press the
The machine is now reprogrammed with the new water hard-
ness setting.
19. TECHNICAL DATA
Voltage:
Absorbed power:
Pressure:
Max. water tank capacity:
Size LxDxH:
Cord length:
Weight:
Max. beans container capacity:
15
high
m a x i -
mum
button (B5) for at least 5 seconds.
,
and
lights come on together;
button (B2) to set the actual water hardness
/
button (B9) to confirm the selection.
220-240 V~ 50/60 Hz max. 10A
1.5MPa (15 bars)
240x440x360 mm
1450W
1.8 l
1150 mm
9.2 kg
250 g
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
