DeLonghi Magnifica S Smart ECAM 250.23.SB Manual page 13

PROBLEM
The coffee is weak or not creamy enough. The coffee is ground too coarsely.
The coffee is delivered too slowly or a
drop at a time.
The infuser (A9) cannot be extracted
At the end of descaling, the appliance
requests a third rinse
The frothed milk has large bubbles
The milk is not frothed
Steam delivery stops
The appliance does not come on
Coffee does not come out of one of the
spouts.
POSSIBLE CAUSE
The coffee is unsuitable.
The coffee is ground too finely.
The appliance has not been turned off
correctly
During the two rinse cycles, the water
tank has not been filled to the MAX level.
The milk is not cold enough or is not
semi-skimmed
The cappuccino maker (A18) and steam/
hot water connection nozzle (A19) are
dirty
A safety device stops steam delivery
The appliance is not plugged into the
mains socket
The main switch (A6) is not pressed
The coffee spouts (A11) are blocked
18
REMEDY
Turn the grinding adjustment dial (A5)
one click anticlockwise towards 1 while
the coffee mill is in operation (fig. 13).
Continue one click at a time until the
coffee is made satisfactorily. The effect is
only visible after delivering 2 coffees (see
section "12.2 Adjusting the coffee mill").
Use coffee for espresso machines.
Turn the grinding adjustment dial (A5)
one click clockwise towards "7" while the
coffee mill is in operation (fig. 13). Con-
tinue one click at a time until the coffee is
made satisfactorily. The effect is only vis-
ible after delivering 2 coffees (see section
"12.2 Adjusting the coffee mill").
Turn the appliance off by pressing the
button (B5) (see section "5. Turning the
appliance off").
Follow the instructions displayed by the
appliance, but first empty the drip tray
(A14) to avoid the water overflowing.
Ideally, use skimmed or semi-skimmed
milk from the refrigerator (about 5°C). If
the result is not as expected, try a differ-
ent brand of milk.
Clean as described in section "16.
Cleaning".
Wait a few minutes and then enable the
steam function again.
Insert the plug (A10) into the mains sock-
et (fig. 1).
Press the main switch (fig. 1).
Clean as described in section "16.7 Clean-
ing the coffee spouts".