Remote Controlling Zone 2/Zone 3 - Yamaha RX-V2500 Owner's Manual

ZONE 2/ZONE 3 (U.S.A., CANADA, U.K., EUROPE AND AUSTRALIA MODELS ONLY)
Using this unit's internal amplifier
To use this unit's internal amplifier, select "Internal" in Zone2 Amplifier 2 (page 66).

Remote controlling Zone 2/Zone 3

The supplied remote control can be used to control
Zone 2/Zone 3. You can even select the input source and
control components located in the main room directly
from the second/third room regardless of the listening
condition in the main room.
To enable Zone mode on the remote
control
You will be able to switch the remote control mode from
one room to another, and use the input selector,
STANDBY, SYSTEM POWER, MUTE and
VOLUME +/– to control the selected room.
1
Set REC OUT/ZONE 2 on the front panel to
SOURCE/REMOTE.
DTV
CBL/SAT
VCR 1
DVR/
VCR2
REC OUT/ZONE 2
2
Repeat steps 1 through 3 of the procedure in
"Setting remote control codes" on page 70.
3
Press l / h to select "L:AMP".
ENTER
4
Press ENTER.
"2000" appears in the display window.
5
Enter the code number "2001" or "2003".
For details, see page 71.
82
R L
+
–
PRESENCE/ ZONE 2
This unit
SOURCE/
REMOTE
DVD MD/TAPE
CD-R
TUNER
CD
Second room
6
Press ENTER to set the number.
"OK" appears in the display window if setting was
successful.
7
Press LEARN to complete the Zone setup.
The remote control will be able to operate this unit
from Zone 2 or Zone 3.
To control Zone 2/Zone 3
1
Press SELECT k repeatedly to display
"ZONE 2" or "ZONE 3" in the display window.
2
Press SYSTEM POWER to turn Zone 2 or
Zone 3 power on.
LEARN
SELECT
or