Manual Setup: Basic - Yamaha RX-V2500 Owner's Manual

Manual setup: Basic

Use this menu to set up basic system parameters.
1
Set AMP/SOURCE/TV to AMP.
AMP
SOURCE
TV
2
Press TOP on the remote control.
3
Select Manual Setup, then press h.
Sound
Basic
Option
4
Select Basic, then press h.
5
Select the desired parameters, then press h
to access and adjust.
• Most of the parameters described in the basic menu are set
automatically when you run auto setup. You can use the basic
menu to make further adjustments, but we recommend running
auto setup first.
• You can reset these parameters by performing the auto setup
procedure (see page 26).
Test Tone (Test tone)
Turns the test tone output on or off for Speaker Set,
Speaker Distance and Speaker Level settings.
Manual Setup > Basic > Test Tone >
Choices: Off, On
Test Tone
Speaker Set
Speaker Distance
y
• If you use a handheld SPL meter, hold at arms length and point
upwards so that the meter is in the listening position. With the
meter set to the 70 dB scale and to C SLOW, calibrate each
speaker to 75 dB.
• This menu item is also available in the front panel display
system options menu (see page 85).
Test Tone
Speaker Set
Speaker Distance
Speaker Level
Off
On
Note
Loud test tones will be output when "On" is selected. In this case,
make sure no children are present in the listening room.
Speaker Set (Speaker set)
Use to manually adjust any speaker setting.
Manual Setup > Basic > Speaker Set >
y
If you are not satisfied with the bass sounds from your speakers,
you can change these settings according to your preference.
Note
Set any THX speakers to Small.
Front (Front speakers)
Choices: Large, Small
Front
Center
Surround
• Select "Large" if you have large front speakers. The
unit directs the entire range of the front left and right
channel signals to the front left and right speakers.
• Select "Small" if you have small front speakers. The
unit directs the low-frequency signals of the front
channel to the speakers selected with Bass Out.
Center (Center speaker)
Choices: Large, Small, None
Front
Center
Surround
Surround Back
• Select "Large" if you have a large center speaker. The
unit directs the entire range of the center channel signal
to the center speaker.
• Select "Small" if you have a small center speaker. The
unit directs the low-frequency signals of the center
channel to the speakers selected with Bass Out.
• Select "None" if you do not have a center speaker. The
unit directs all of the center channel signal to the front
left and right speakers.
SYSTEM OPTIONS
Large
Small
Large
Small
None
61