Yamaha RX-V2095 Owner's Manual page 38

PREPARATION
11
For the front effect speaker level adjustment, press
the TEST key on the remote controller again so that
"TEST DSP" appears on the display.
Remote control
TEST
A calibration signal should be heard from the main
speakers and the front effect speakers in turn.
12
Adjust the front effect speaker level by pressing the
+ or – key so that it becomes almost the same as
the main speakers.
* While adjusting, the test tone is fixed on the front
effect speaker.
* Pressing the
on the left front effect speaker and the right front
effect speaker respectively. This is helpful for you
to check that each speaker is correctly connected
to this unit.
34
11, 13
Main
Front effect
Remote control
or key makes the test tone fix
1 2 3 PHONO
JAZZ ROCK ENTER-
CLUB CONCERT TAINMENT
4 5 6 EXT. DEC.
CONCERT TV
STADIUM VIDEO THEATER
EFFECT
7 8 9
MOVIE MOVIE / DTS ON/OFF
THEATER 1 THEATER 2 SURROUND
10 11 12
LEVEL
PARAMETER
12
TEST
SET MENU
SLEEP ON SCREEN
MASTER VOLUME
SYSTEM
POWER ON
TV
MUTE
VCR
STANDBY
13
When the adjustment is finished, press the TEST
key once again to cancel the test tone.
Remote control
TEST
Notes
Once you have completed these adjustments, you can
adjust the sound level on your audio system by using the
VOLUME control (or the MASTER VOLUME keys on the
remote controller) only.
If you use external power amplifiers, you may also use
their volume controls to obtain proper balance.
If the function "1A. CENTER SP" in the SET MENU mode
is set in the "NONE" position, in step 10, the sound output
level of the center speaker cannot be adjusted. This is
because in this mode, the center sound is automatically
output from the left and right main speakers.
If there is insufficient sound output from the center and
rear speakers, you may decrease the main speaker
output level by setting the function "1F. MAIN LEVEL" in
the SET MENU mode in the "–10dB" position.
Disappears