Speakers - Yamaha RX-V2095 Owner's Manual

PREPARATION

Speakers

Use speakers with the specified impedance shown on the rear of this unit.
Center speaker
Subwoofer system
How to Connect:
Connect the SPEAKERS terminals to your speakers with the wire of the proper gauge (keep as short as possible). If the
connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct. That is
the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit or the
speakers, or both.
Red: positive (+)
Black: negative (–)
2
1
3
22
Front effect speakers
Right Left
CENTER
IN OUT
REMOTE
CONTROL
COUPLER OUTPUT
MAIN CENTER FRONT REAR
( SURROUND )
PRE MAIN
OUT IN
SUB
WOOFER
Right
Loosen the knob.
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
Tighten the knob and
secure the wire.
Rear speakers
Right
SPEAKERS
FRONT REAR
( SURROUND )
CAUTION
SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
MAIN
A
A
B
B
Left
Main speakers B
<
U.S.A., Canada, China, Australia and General models
>
only
Banana Plug connections are also possible. Simply insert the
Banana Plug connector into the corresponding terminal.
Left
IMPEDANCE SELECTOR
SET BEFORE POWER ON
CENTER : 4 MIN. / SPEAKER
FRONT : 6 MIN. / SPEAKER
REAR : 4 MIN. / SPEAKER
MAIN A OR B: 4 MIN. / SPEAKER
A B : 8 MIN. / SPEAKER
CENTER : 8 MIN. / SPEAKER
FRONT : 8 MIN. / SPEAKER
REAR : 8 MIN. / SPEAKER
MAIN A OR B: 8 MIN. / SPEAKER
A B : I 6 MIN. / SPEAKER
Right
Main speakers A
Left