Toyotomi TRN-828ZR User Manual page 22

NOTE:
•
Outdoor temperature display is not available. At that time, indoor unit
receives signal, while it displays indoor set temperature.
•
lt is defaulted to display set temperature when turning on the unit.
There is no display in the remote controller.
•
When selecting displaying of indoor or outdoor ambient temperature,
indoor temperature indicator displays corresponding temperature and automatically
turn to display set temperature after three of five seconds.
FUNCTION INTRODUCTION FOR COMBINATION BUTTONS
ENERGY-SAVING FUNCTION
Under cooling mode, press "TEMP" and "CLOCK" buttons simultaneously to start up or
turn off energy-saving function. When energy-saving function is started up, "SE" will be shown
on remote controller and air conditioner will adjust the set temperature automatically accor-
ding to ex-factory setting to reach to the best energy-saving effect. Press "TEMP" and "CLOCK"
buttons simultaneously again to exit energy-saving function.
NOTE:
•
Under energy-saving function, fan speed is defaulted at auto speed and it can't be
adjusted.
•
Under energy-saving function, set temperature can't be adjusted. Press "TURBO" button
and remote controller won't send signal.
•
Sleep function and energy-saving function cannot operate at the same time.
lf energy-saving function has been set under cooling mode, press sleep button to cancel
energy-saving function. lf sleep function has been set under cooling mode, start up the
energy-saving function to cancel sleep function.
22
GB