Toyotomi TRN-828ZR User Manual page 14

•
When selecting heating mode, the air conditioner operates under heat mode. Heat indica-
tor on indoor unit is ON (This indicator is not available for some models). Press " " or "
" button to adjust set temperature. Press "FAN" button to adjust fan speed. Press
button to adjust fan blowing angle. (Cooling only unit won't receive heating mode signal.
lf setting heat mode with remote controller, press ON/OFF button can't start up the unit).
NOTE:
•
For preventing cold air, after starting up heating mode, indoor unit will delay 1~5 minutes
to blow air (actual delay time is depending on indoor ambient temperature).
•
Set temperature range from remote controller: 16°C~30°C (61-86°F); Fan speed: auto, low
speed, low-medium speed, medium speed, medium-high speed, high speed.
FAN button
3
This button is used for setting Fan Speed in the sequence that goes from
AUTO,
Auto
Low speed
NOTE:
•
It's Low fan speed under Dry mode
•
X-FAN function: Hold fan speed button for 2s in COOL or DRY mode, the icon "
displayed and the indoor fan will continue operation for a few minutes in order to dry
the indoor unit even though you have turned off the unit. After energization, X-FAN OFF
is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
This function indicates that moisture on evaporator of indoor unit will be blowed after the
unit is stopped to avoid mould.
•
Having set X-FAN function on: After turning off the unit by pressing ON/OFF button indoor
fan will continue running for a few minutes. at low speed. In this period, hold fan speed
button for 2s to stop indoor fan directly.
•
Having set X-FAN function off: After turning off the unit by pressing ON/OFF button, the
complete unit will be off directly.
, , ,
Low Medium speed
Medium - High speed
to , then back to Auto.
High speed
14
Medium speed
/
" is
GB