Yamaha Digital Sound Projector YSP-3050 Owner's Manual page 97

Parameter to be changed and front panel display
FACTORY PRESET
You can reset all of the parameters of this unit to the factory presets. This procedure
completely resets ALL the parameters in SET MENU.
Note
After performing the following procedure you must run
sound environment.
7
Press STANDBY/ON on the remote control to
set this unit to the standby mode.
STANDBY/ON
The new setting will be activated when you turn on the
power of this unit next time.
y
When the demo mode is turned on, restart the unit, then press
ENTER while playing back sources to test the sound beam.
The sound beam being output shuttles between left and right.
Press ENTER again to stop shuttling.
AUTO SETUP
again to match your surround
Adjusting the system parameters
Parameter settings
RESET, CANCEL
93
En