Controls And Functions; Front Panel - Yamaha RX-V2400 Owner's Manual

CONTROLS AND FUNCTIONS

Front panel

1 2
INPUT
STANDBY
/ON
SPEAKERS MULTI CH INPUT MODE
A B
INPUT
0 A B
1 STANDBY/ON
Turns on this unit or sets it to the standby mode. When you
turn on this unit, you will hear a click and there will be a 4
to 5-second delay before this unit can reproduce sound.
Note
In standby mode, this unit consumes a small amount of power in
order to receive infrared-signals from the remote control.
2 INPUT selector
Selects the input source you want to listen to or watch.
3 Remote control sensor
Receives signals from the remote control.
4 Front panel display
Shows information about the operational status of this
unit.
5 PRESET/TUNING EDIT
Switches the function of PRESET/TUNING l / h
between selecting preset station numbers and tuning.
6 FM/AM
Switches the reception band between FM and AM.
4
CONTROLS AND FUNCTIONS
3 4 5
SOURCE PRESET/
/REMOTE
A/B/C/D/E TUNING /TUNING
DVD MD/TAPE
DTV CD-R
CBL/SAT TUNER
VCR 1 CD
DVR
/VCR2
REC OUT/ZONE 2 OPTIMIZER
MIC
C D E F G
6 7 8
PRESET TUNING
FM/AM MEMORY MODE
EDIT MAN'L/AUTO FM AUTO/MAN'L MONO
PHONES S VIDEO VIDEO L AUDIO R OPTICAL
SILENT VIDEO AUX
RDS MODE
/FREQ EON
H
MODE
L M
(U.K. and Europe models only)
7 MEMORY (MAN'L/AUTO FM)
Stores a station in the memory. Hold down this button for
more than 3 seconds to start automatic preset tuning.
8 TUNING MODE (AUTO/MAN'L MONO)
Switches the tuning mode between automatic ("AUTO"
indicator on) and manual ("AUTO" indicator off).
9 VOLUME
Controls the output level of all audio channels.
This does not affect the REC OUT level.
0 SPEAKERS A/B
Turn on or off the set of front speakers connected to the A
and/or B terminals on the rear panel at each time the
corresponding button is pressed.
A MULTI CH INPUT
Selects the source connected to the MULTI CH INPUT
jacks. When selected, the MULTI CH INPUT source takes
priority over the source selected with INPUT (or the input
selector buttons on the remote control).
B INPUT MODE
Sets the priority (AUTO, DTS, ANALOG) for the type of
signals received when one component is connected to two
or more of this unit's input jacks (see page 34). Priority
cannot be set when MULTI CH INPUT is selected as the
input source.
9
(U.S.A. model)
VOLUME
PROGRAM
TONE CONTROL
PTY SEEK
I J
START
N O
STRAIGHT
EFFECT
K